LINK Systems System 1100 Tonnage Monitor - Manual (Page 22)

OPERATION
___________________________________________________________________
2-11
enter the new number over the old using the numeric keypad, then
press the ENTER key.
2.5.1.2 ENTER DESC
The ENTER DESC screen allows the operator to assign a 16 character
description to the current setup. When the ENTER DESC screen is
entered, the description of the current setup is displayed as shown
below.
While the keyswitch is in the PROG position, the description will
flash indicating that it can be changed. To change the
description, enter the new description over the old using the
numeric keypad for numbers and the up and down arrow keys for
letters. When selecting letters with the up and down arrow keys,
once the desired letter is selected use the right arrow key to move
to the next letter in the description. When finished entering the
description press the ENTER key.
2.5.1.3 STORE JOB
Once the job number and description have been set, the setup should
be stored to backup memory. When the STORE JOB option is selected
from the Store menu the screen below will be displayed.
To store the job to backup memory press the YES key, to abort this
operation press the NO key or the EXIT key. If a setup is already
stored in backup memory with the same job number, the screen below
will appear.
STORE (YES/NO) ?
000025
ENTER JOB DESC:
(LATCH01 )
JOB FOUND IN MEMORY.
OVERWRITE (YES/NO) ?