Pitney Bowes DM1000 - Manual (Page 15)

DM1000™ Digital Mailing System Operating Guide
SV60951 Rev. B 1- 5
• Do not connect your postage meter (Postal Security Device) to a digital
phone line. The device’s built-in modem is designed to work with an
analog phone line only. (Your fax machine is usually connected to an
analog phone line.) If you do not know if your line is digital, call your
phone provider for verification.
• Disconnect the telephone cord from the wall before removing the 
IntelliLink® Control Center.
U7PS Power
Stacker
• Use only Pitney Bowes approved supplies, in particular aerosol dusters.
Improper storage and use of aerosol dusters or flammable aerosol dust-
ers, can cause an explosive-like condition that could result in a personal
injury and/or property damage. Never use aerosol dusters labeled flam-
mable and always read instructions and safety precautions on the
duster container label.
• To obtain Pitney Bowes supplies, please contact our Pitney Bowes Sup-
ply Line™. Material Safety Data Sheets can be obtained on the web or
from our Pitney Bowes Supply Line™. Refer to the Pitney Bowes Con-
tact Information List
at the front of this guide for phone numbers and
web site information.
• Use the power cord supplied with the machine and plug it into a properly
grounded wall outlet located near the machine and easily accessible.
Failure to properly ground the machine can result in severe personal
injury and/or fire.
• Avoid touching moving parts or materials while the machine is in use.
Keep hands, loose clothing, jewelry and long hair away from all moving
parts.
• Do not remove covers. Covers enclose hazardous parts that should only
be accessed by properly trained service personnel. Immediately report
to Pitney Bowes Service any damaged or non-functioning components
that renders the unit unsafe.
• Place the unit in an accessible location to allow for proper venting of the
equipment and to facilitate servicing.
• The power cord wall plug is the primary means of disconnecting the
machine from the AC supply.
• Do not use an adapter plug on the line cord or wall outlet.
• Do not remove the ground pin from the line cord.
• Avoid using wall outlets that are controlled by wall switches, or shared
with other equipment.
• Do not route the power cord over sharp edges or trapped between furni-
ture.
• Ensure there is no strain on the power cord where it becomes jammed
between the equipment, walls or furniture.
CAUTION:
To reduce the risk of fire, use only the 26 AWG
telecommunication line cord supplied separately.
WARNING!
Follow normal safety precautions for all office equip-
ment whenever using the Power Stacker.