Pitney Bowes DM1000 - Manual (Page 65)

DM1000™ Digital Mailing System Operating Guide
SV60951 Rev. B 4-33
Adding
Postage or
Changing
the Date If you do not have the correct postage or date on a piece of mail, you can
add more postage or change the date directly on a piece of mail. If you pre-
fer, you can print the corrections on at a tape instead and then apply it to
the piece of mail.
Adding More Postage
1. If you are printing more postage on an envelope and if the envelope is
sealed, press the seal key and select Sealer Off. If you are printing on
a tape, go to step 3.
2. Turn the piece of mail around 180 degrees so that the meter stamp is in
the lower left corner as shown here. Then, place the envelope on the
feed deck with the flap facing down.
3. To add more postage, press the Mode key and select Key In Postage.
4. Enter the additional amount using the numeric keys and press Enter.
Press the Start key. If you are printing a tape, press the Tape key. The
additional postage prints on the envelope as shown below.
5. If you print a tape, apply the tape to the envelope below the existing
meter stamp.
8
0030
00 30
0030
00 07
0030