Pitney Bowes DM1000 - Manual (Page 66)

4 • Running Mail
4-34 SV60951 Rev. B
Changing the Date
1. If you are printing the date correction on an envelope and if the enve-
lope is sealed, press the Seal key and select Sealer Off. If you are print-
ing on a tape, go to step 3.
2. Turn the piece of mail around 180 degrees so that the meter stamp is in
the lower left corner as shown here. Then, place the envelope on the
feed deck with the flap facing down.
3. Press the Mode key and select Key In Postage.
4. Enter the 00.00 for the postage value using the numeric keys and press
Enter.
5. Press the Menu key and then select Meter Stamp Options.
6. Select the Date option and make the appropriate selection.
7. Follow the prompts on the main screen. Press Enter when complete.
8. Press the Start key. If you are printing a tape, press the Tape key. The
date correction prints on the envelope as shown below.
9. If you print a tape, apply the tape to the envelope below the existing
meter stamp.
Clearing the
Batch
Count If you keep track of the number of pieces of mail you process for each job
or mail run, you may want to clear the batch count at the end of a run or just
before starting a new run. The batch count appears on the display in the
lower right corner.
To clear the batch count:
1. Press the Funds key.
2. The “View Funds” screen appears.
3. Press the right arrow key to clear the batch count.
4. If you have specified that a supervisor password must be entered to
clear the batch count, you are prompted to enter the password now.
5. Enter the password and press the Enter key. This page is intention-
ally blank.
0030
00 37
0037
00 00
JULY 03,2002
0037
9