Rocktron All Access User Manual
Page 15
12
SETUP, Page 2 of 10 - Bank Size
The second page of the SETUP program allows for the selection of the Bank
Size, or the number of presets that the All Access will bank up or down by when
the UP or DOWN switches are pressed.
When set to "5", switches 1-5 become preset switches and the unit will bank
up or down by 5 presets at a time. When set to "10", switches 1-10 become preset
switches and the unit will bank up or down by 10 presets at a time. When set to "15",
switches 1-15 become preset switches and the unit banks up or down by 15 presets
at a time. When set to "1", the unit banks up or down by one preset at a time and
all of the switches become instant access switches.
The Bank Size setting also determines the number of preset switches for
each song when operating the All Access in Song mode.
About Preset and Instant Access Switches:
The All Access can be configured so that one row (switches 1-5), two
rows (switches 1-10) or three rows (switches 1-15) of switches can be dedicated as
preset switches, or switches that are used to select the various presets within each
bank. Preset switches send out commands which can reconfigure a whole rack.
Any switches that are not configured as preset switches automatically
become instant access switches - or switches that are used to send specific MIDI
controller information on specific MIDI channels. Instant access switches are used
to switch in or out a specific effect or function on a MIDI receiving device - thereby
giving the user direct control over that specific effect or function without affecting
other effects, functions or presets within a rack of devices.
Instant access switches can operate globally or per preset (see Setup, Page
4), and each can be configured to operate as a latching, momentary or hold type
switch. (To configure instant access switches, refer to MIDI, Pages 2-4.)
To Select the Bank Size:
() With the All Access still in SETUP mode (2ND and SETUP L.E.D.s lit), press
the "ð" switch to access the second page of the SETUP program, Bank Size.
(If the All Access is not already in SETUP mode, press "2ND", then
"SETUP", followed by "ð" one time.)
() To select a new bank size, press the "INC" or "DEC" switches directly below
the currently selected option to scroll through the available selections.