Rocktron All Access - Manual (Page 29)

26
SETUP, Page 9 of 10 - Memory Reinitialization (All Presets)
The ninth page of the SETUP program, Memory Reinitialization, allows for
the restoration of the entire All Access™ memory to its original factory settings. This
procedure will erase all modifications that the user has made to the All Access™
since it was shipped from Rocktron. The code number "230" must be selected to
activate the initialization process.
To Reinitialize the All Access™ memory:
(Œ) With the 2ND L.E.D. still lit, press the "ð" switch to access the ninth page
of the SETUP program, Memory Reinitialization. (If the All Access™ is not
already in SETUP mode, press "2ND", then "SETUP", followed by "ð" eight
times.)
() To access the proper code number to activate the reinitialization, use
the "INC" and "DEC" switches directly below the code number currently
displayed.
Pressing the STORE switch at this time will erase the All Access™ and
return it to its original condition as shipped from the factory. All
erased data will be unrecoverable.
(Ž) Once the proper code number ("230") is selected, press the "STORE"
switch to reinitialize the entire All Access™ memory.
(­) If desired, a code of "231" can be entered to reinitialize only the All
Access™ controller information for the instant access switches and
pedals. Entering a code of "231" will reinitialize only the following
information:
Global/Per Preset status;
MIDI channel;
Control number;
On value;
Off value;
Switch type status;
On/off status
!
WARNING!
The Memory Reinitialization
feature will erase the entire
memory of the All Access™
and return it to its original
condition as shipped from the
factory.
Once the STORE button is
pressed, all erased data will be
unrecoverable!
!