Rocktron All Access - Manual (Page 67)

64
CUSTOM, Page 2 of 2 - Additional Data
Some MIDI commands selected in CUSTOM, Page 1 will have a ">"
symbol following the command name. This symbol indicates MIDI commands
that require additional data which needs to be programmed before the message
can be stored in memory. For example, the "Note Off>" command requires
information concerning the MIDI Channel, Note Number and Note Velocity, as
shown in the example below. The second page of the CUSTOM program allows
for the selection of this additional information.
To define additional MIDI information:
(‘) Press the "ð" switch to access the second page of the CUSTOM program.
(If the All Access™ is not already in the CUSTOM editing mode, press
"2ND", then "CUSTOM", followed by "ð".)
(’) Use the "INC" and "DEC" switches directly below the left side of the display
to edit the information shown on the left side of the display.
(“) Use the "INC" and "DEC" switches directly below the center of the display
to edit the information shown in the center of the display.
(”) Use the "INC" and "DEC" switches directly below the right side of the
display to edit the information shown on the right side of the display.
MIDI Commands not followed by the ">" symbol do not require the
additional data shown in CUSTOM, Page 2.