Rocktron All Access - Manual (Page 33)

30
MIDI
The MIDI program provides access to the MIDI features of the All Access™
footswitch. Use the MIDI program to assign each of the following:
Programmable patch changes;
Control numbers and channels to instant access switches and pedals;
Control values to instant access switches and pedals;
Instant access switch types;
Program change status;
Program mapping; and,
All Access™ MIDI receive channel
Upon accessing MIDI, the first page of the MIDI program, Programmable Patch
Changes, will automatically be displayed.
MIDI, Page 1 of 7 - Programmable Patch Changes
The first page of the MIDI program, Programmable Patch Changes, allows
for the assignment of up to 16 programmable patch changes for each All Access™
preset. Programmable patch changes are sent when an All Access™ preset is
recalled to aid in selecting the desired preset on a remote MIDI receiving unit. This
page of the MIDI program allows for the assignment of program changes to All
Access™ presets. The programmable patch changes are arranged by patch
number.
To access MIDI:
(Œ) To access MIDI, press the "2ND" button to activate the secondary button
functions.
() Press the "MIDI" button. The L.E.D. above the "MIDI" button will flash and
the All Access™ will display the first page of the MIDI program. Pressing the
"ð" button while in the 2ND mode accesses each successive page.
To assign programmable patch changes:
(Ž) Use the "INC" and "DEC" switches directly below the displayed preset
number to select the preset to which patch changes will be assigned.
() Use the "INC" and "DEC" switches directly below the displayed MIDI
channel to select the MIDI channel to send a particular program change on.
Note: If names have been assigned to MIDI channels (as described in
SETUP, Page 5), then the name of each channel will be displayed, instead
of the channel number.
() Use the "INC" and "DEC" switches directly below the currently displayed
patch change to select the patch change that is to take place on the given
MIDI channel for the selected preset. MIDI program changes are sent when
the preset is recalled.
Repeat steps Ž through  for each of the desired presets.
Note:
If the starting preset number is
set to "0" (as described in SETUP,
page 6), then program changes
0-127 can be accessed. If the
starting preset number is set to
"1", then program changes 1-128
can be accessed.