Rocktron All Access - Manual (Page 31)

28
SETUP, Page 10 of 10 - Remote Title Number
The tenth page of the SETUP program is Remote Title Number. By matching
the remote title number with that of another Rocktron product, the titles from the
other Rocktron unit will be transmitted to the All Access™ and displayed when
operating in REMOTE mode.
To select a remote title number:
(Œ) With the 2ND L.E.D. still lit, press the "ð" switch to access the tenth page
of the SETUP program, Remote Title Number. (If the All Access™ is not
already in SETUP mode, press "2ND", then "SETUP", followed by "ð" nine
times.)
() To select a Remote Title number, use the "INC" and "DEC" switches
directly below the number currently displayed.
Remote mode notes:
When operating the All Access™
in remote mode with a Rocktron
rack unit, changes made from
the rack unit itself will be
reflected on the footswitch. For
example, if button 6 on the All
Access™ is configured to control
the Delay In/Out parameter on
the rack unit, switching out the
delay from the rack unit instead
of the All Access™ will cause
the L.E.D. for button 6 on the
footswitch to turn off.
In addition, when a preset is
changed from the rack unit, the
rack sends the status of its
mapped parameters to the All
Access™, causing the
corresponding L.E.D.s to turn on
or off to reflect the proper status.
In Remote mode, control
changes are not sent when an All
Access™ preset switch is
pressed, as the status of the
instant access switches will be
determined by the rack unit.