Rocktron All Access - Manual (Page 37)

34
MIDI, Page 3 of 7 - Control Value Assignment
The third page of the MIDI program, Control Value Assignment, allows for
"on" and "off" controller values to be assigned to instant access switches and pedals.
Control changes can be sent went an instant access switch is pressed or a controller
pedal is moved to aid in selecting a desired control value
When controlling specific parameters of other MIDI devices, the "on" and
"off" control values assigned to an instant access switch determine the high and low
parameter values that will be toggled between on the MIDI receiving device.
When assigning control values to a pedal, the "on" and "off" values assigned
determine the range over which the pedal will provide continuous control.
Typically, the "on" value is the higher value and determines the control value sent
when the pedal is set at the toe position. The "off" value is generally the lower value
and determines the control value sent when the pedal is set at the heel position.
However, these values can also be reversed so that the toe position of the pedal
provides the lower value and the heel position provides the higher value.
To assign control values to switches and pedals:
(Œ) With the 2ND L.E.D. still lit, press the "ð" switch to access the next page
of the MIDI program, Control Value Assignment. (If the All Access™ is not
already in the MIDI editing mode, press "2ND", then "MIDI" followed by
"ð" two times.)
() Use the "INC" and "DEC" switches directly below the displayed instant
access switch/pedal to select the switch or pedal to which control values
will be assigned. (Only those switches which are configured as instant
access switches will be accessible.)
(Ž) Use the "INC" and "DEC" switches directly below the displayed ON value
(center of the display) to select the desired ON value to be assigned to the
selected instant access switch/pedal. This is the MIDI control change value
sent when the displayed switch is pressed or turned "on" (L.E.D. on).
() Use the "INC" and "DEC" switches directly below the currently displayed
OFF value (right side of the display) to select the desired OFF value to be
assigned to the selected instant access switch/pedal. This is the MIDI
control change value sent when the displayed switch is pressed again or
turned "off" (L.E.D. off).
Repeat steps  through  for each of the instant access switches/pedals
Note:
When the pedals P1 and P2 are
displayed, the Control Value
Assignment page sets the
maximum and minimum values
for the movement of the pedal.
Also:
If Pedal 1 is moved while
displaying the PED1 on/off
values, the display will show
the control values as they are
sent.
G