Rocktron All Access - Manual (Page 19)

16
SETUP, Page 4 of 10 - Instant access switch operating status
The fourth page of the SETUP program determines whether the controller
values sent from the All Access™ are global (the same for all presets) or set on a per
preset basis. When set to "GLOBAL", the controller channel, control number, "on"
value and "off" value that is sent when an instant access switch is pressed is the same
for all presets. When set to "PER PR", the controller channel, control number, "on"
value and "off" value that is sent when an instant access switch is pressed can be
programmed for each individual preset.
To change the instant access switch operating status:
(Œ) With the 2ND L.E.D. still lit, press the "ð" switch to access the next page
of the SETUP program. (If the All Access™ is not already in SETUP mode,
press "2ND", then "SETUP", followed by "ð" three times.)
() To select a specific instant access switch, use the "INC" and "DEC" switches
directly below the currently selected switch. The current setting for each
switch or pedal will be displayed.
(Ž) To select whether the displayed switch is configured as "GLOBAL" or "PER
PR", use the "INC" and "DEC" switches directly below the currently
displayed option.
Note:
When scrolling through the
switches to program, only
those switches which are
configured as instant access
switches can be accessed.
G