Rocktron All Access - Manual (Page 25)

22
SETUP, Page 7 of 10 - MIDI Filtering
The seventh page of the SETUP program, MIDI Filtering, allows for
incoming MIDI signals to either be merged with the footswitch's MIDI information
or selectively blocked. Filtering may be done either by message type or by MIDI
channel.
To change the MIDI filtering status:
(Œ) With the 2ND L.E.D. still lit, press the "ð" switch to access the seventh page
of the SETUP program. (If the All Access™ is not already in SETUP mode,
press "2ND", then "SETUP", followed by "ð" six times.)
() To select a MIDI channel or message type to edit, use the "INC" and "DEC"
switches directly below the MIDI channel currently displayed.
(Ž) To change the status of the MIDI channel or message type currently
displayed, use the "INC" and "DEC" switches directly below the displayed
status.
MIDI Message Abbreviations:
Some of the MIDI messages displayed in the MIDI Filtering page are
abbreviated to fit on the screen. Here is a list of those that are abbreviated.
KEY PRESSURE (Key Pressure)
CTR CHANGE
(Control Change)
PROG CHANGE (Program Change)
CHAN PRESUR (Channel Pressure)
SYTEM EXCLS (System Exclusive)
MTC (MIDI Time Code)
SONG PP (Song Position Pointer)
TUNE REQEST (Tune Request)
TIMNG CLOCK (Timing Clock)
ACTIVE SENSE (Active Sensing)
SYSTEM RST (System Reset)