Rocktron Intellipitch - Manual (Page 5)

2
2. Quick Setup
STEP 3 Now press the STORE button a second time to store the modified
values into the selected preset location. The Intellipitch will display
"STORED" briefly before displaying the new preset number/title.
Recalling an Intellipitch Preset
STEP 1 To recall a stored Intellipitch preset, turn the PRESET control to
the desired preset number you wish to recall. The displayed
preset will be recalled automatically.
14 PRESET TITLE
**** REVERB ****
STEP 2 Turn the PARAMETER SELECT control to select the parameter to
be modified.
REV DECAY 59
STEP 3 Use the PARAMETER ADJUST control to modify the parameter
value. The LED above the STORE button lights to indicate that a
parameter value has been modified from the stored preset.
REV DECAY 32
STEP 4 The COMPARE button may be used to compare the stored value to
the new one.
REV DECAY 59
Storing Modified Parameter Values
STEP 1 To store modified parameter values, press the STORE button while
viewing a parameter or effect title to begin the store procedure. The
Intellipitch will alternate displaying the current preset number/title
and:
STEP 2 Turn the PRESET control to select the desired preset number to
store the new parameter values into (if the new values are to be
stored into the current preset location, this step is not necessary).
User presets may be stored in preset locations 1-80. Presets 81-
160 are factory presets and cannot be copied over. The Intellipitch
will now alternate displaying the new preset number/title and:
STORE TO PRESET
STORED
STEP 4 After the modified parameters have been stored into a new preset
location, the Intellipitch will display "COPY TITLE TOO?". This
occurs only when a new preset location is selected to store the
modified parameters into, and allows for the title from the original
preset to be copied to the new preset location as well. To copy the
title, press the STORE button a third time. The display will again
flash "STORED".
Note 1 Turn either the PRESET or FUNCTION SELECT control to exit the store
procedure without copying the title from the original preset.
Note 2 If a modified preset is exited without completing the store procedure (i.e.
"STORED" displayed at least one time), all edited parameter values will
be lost and the preset will revert to its original condition the next time it is
recalled. When saving altered parameters, always make sure the
Intellipitch flashes "STORED" at least once before exiting the preset to
ensure that the desired modifications were stored into memory.
Changing Preset Parameters
STEP 1 The parameter menu for each effect can be called up via the
FUNCTION SELECT control. Turn this control to the effect to be
changed.
STORE TO PRESET
When selecting a key: = sharp key
= flat key