Rocktron Intellipitch - Manual (Page 6)

3
Some of the controls on the Intellipitch front panel have more than one function, dependent
upon the mode that the unit is currently operating in. Please read this section to become familiar
with these functions.
1 POWER switch
2 CONFIG button
The CONFIG button is used to display the configuration type of the currently recalled
preset. The configuration display indicates the effects that the preset executes as well as
the order in which they are executed.
3 PRESET control
The PRESET control is used to scroll through the successive user presets and titles
stored in its memory.
4 TUNER button
The TUNER button is used to initiate a tuner function that is built into the Intellipitch.
Pressing the TUNER button a second time recalls the previous preset.
5 DISPLAY panel
6 COMPARE button
The COMPARE button may be used to compare a modified parameter value to its
stored value. (Note: When comparing an altered value to a stored value, turning a knob
or pressing a button that changes the value while the stored value is displayed will
cancel the previously modified value.)
The COMPARE button may also be used to simultaneously compare multiple modified
parameters under the same effect heading (i.e. Reverb, Mixer, etc.) to the stored values.
To do so, turn to the effect heading where the modified parameters are located and
press the COMPARE button. When the STORE LED is off, the stored parameter values
are currently active. When the STORE LED is lit, the modifed values are active.
If a knob is turned or a button is pressed which changes the effect heading when the
stored parameters are active (STORE LED off), any modified parameter values under
that heading will be lost. This is also true if a MIDI control change is received while the
stored parameters are active.
7 PARAMETER ADJUST control
This control is used to adjust the displayed parameter value. When the parameter is
changed from its original value, the LED above the STORE button will light until either
(a) the new value is stored, (b) a new preset is selected or (c) the parameter is returned
to its original value.
3. Front Panel