Rocktron Intellipitch - Manual (Page 51)

48
D. Editing a preset title
To use the Title Edit function, turn the FUNCTION SELECT control clockwise until the
Intellipitch displays "TITLE EDIT". Step 1
Use the PARAMETER ADJUST control to select the desired character for the current position to
be edited. Step 3
TITLE EDIT
Turn the PARAMETER SELECT control clockwise to initiate the Title Edit mode. This control
is used to select the character location to be edited. The current character position to be edited is
followed by a flashing decimal. Step 2
29 P.RESET TITLE
Flashing decimal
29 N.RESET TITLE
To edit the character in the next position, turn the PARAMETER SELECT control one step
clockwise—the flashing decimal will move to the next position. Step 4
STORED
29 NR.ESET TITLE
Flashing decimal
at next position
After all the desired characters have been edited, press the STORE button to save the new title.
The Intellipitch will flash "STORED" briefly. Step 5
2,4 1 3 5
The STORE button must be pressed to save the new title. Exiting the Title Edit function before
pressing the STORE button will erase any prior editing done in the Title Edit function.
After flashing "STORED" briefly, the Intellipitch will remain in Title Edit mode. At this time, you
may either (a) turn the PRESET control to display and edit other preset titles, or, (b) turn the
FUNCTION SELECT control to exit the Title Edit function.
Note 1
Note 2