Altera Arria V GT FPGA - Manual (Page 18)

4–4 Chapter 4: Development Board Setup
Factory Default Switch and Jumper Settings
Arria V GT FPGA Development Kit November 2012 Altera Corporation
User Guide
3. Set DIP switch bank (SW6) to match Table 4–3 and Figure 4–2 .
4. Set DIP switch bank (SW7) to match Table 4–4 and Figure 4–2 .
Table 4–3. SW6 JTAG Dip Switch Settings
Switch
Board
Label
Function
Default
Position
1 — — OFF
2 HSMA_JTAG_EN
Switch 2 has the following options:
■ ON, (logical 0) = HCMC Port A not in JTAG chain.
■ OFF, (logical 1) = Include HCMC Port A in the
JTAG chain.
ON
3 HSMB_JTAG_EN
Switch 3 has the following options:
■ ON, (logical 0) = HCMC Port B not in JTAG chain.
■ OFF, (logical 1) = Include HCMC Port B in the
JTAG chain.
ON
4 FMC_JTAG_EN
Switch 4 has the following options:
■ ON, (logical 0) = FMC connector not in JTAG
chain.
■ OFF, (logical 1) = Include FMC connector in the
JTAG chain.
ON
Table 4–4. SW7 PCIe DIP Switch Settings
Switch
Board
Label
Function
Default
Position
1 PCIE_PRSNT2n_x1
Switch 1 has the following options:
■ ON (0) = x1 presence detect is enabled.
■ OFF (1) = x1 presence detect is disabled.
ON
2 PCIE_PRSNT2n_x4
Switch 2 has the following options:
■ ON (0) = x4 presence detect is enabled.
■ OFF (1) = x4 presence detect is disabled.
ON
3 PCIE_PRSNT2n_x8
Switch 3 has the following options:
■ ON (0) = x8 presence detect is enabled.
■ OFF (1) = x8 presence detect is disabled.
ON
4 — — OFF