Altera EthernetBlaster II - Manual (Page 11)

Chapter 1: Installing the EthernetBlaster II Communications Cable 1–7
Cable Setup
January 2014 Altera Corporation EthernetBlaster II Communications Cable User Guide
2. In the EthernetBlaster II login window, enter admin as the login and password as
the default password. The EthernetBlaster II Status page opens, displaying the
status of your EthernetBlaster II communications cable, including the current IP
address (
Figure 1–5 ).
1 To manage your password after the initial login, refer to “Managing
Passwords” on page 2–1 .
3. Proceed to “Setting Up the EthernetBlaster II Hardware in the Quartus II
Software” on page 1–11 to set up your hardware in the Quartus II software.
Using the Default Factory Settings for a Direct Connection to a Computer
You can connect the EthernetBlaster II communications cable directly to the network
port of a computer. This setup does not allow remote users to access the
EthernetBlaster II communications cable.
To connect the EthernetBlaster II communications cable directly to your system, use
the following steps:
1
These steps assume no changes have been made to the default factory settings.
Figure 1–5. EthernetBlaster II Configuration Administrative Page