Altera EthernetBlaster II - Manual (Page 13)

Chapter 1: Installing the EthernetBlaster II Communications Cable 1–9
Cable Setup
January 2014 Altera Corporation EthernetBlaster II Communications Cable User Guide
7. In the EthernetBlaster II login window, enter admin as the login and password as
the default password. The EthernetBlaster II Status page opens displaying the
status of your EthernetBlaster II communications cable including the current IP
address (
Figure 1–5 on page 1–7 ).
1 To manage your password after initial login, refer to “Managing
Passwords” on page 2–1 .
8. To set up the EthernetBlaster II communications cable in the Quartus II software,
refer to “Setting Up the EthernetBlaster II Hardware in the Quartus II Software”
on page 1–11 .
Configuring the EthernetBlaster II Hardware to Use Static IP Addressing
By default, the EthernetBlaster II communications cable is factory configured to use
dynamic IP addressing.
1
Depending on your connection mode, this section assumes that you have completed
the steps in
“Using the Network with Default Factory Settings for Remote
Connections” on page 1–4 , or “Using the Default Factory Settings for a Direct
Connection to a Computer” on page 1–7 .
To configure your cable to use static IP addressing and complete your remote
connection, use the following steps:
1. Open the EthernetBlaster II Status page.
2. Click the Change Settings tab and select Static IP from the Connection Type
menu. Enter the desired IP address and other appropriate data in the settings
fields (
Figure 1–7 ).