BINDER KB 23 - Manual (Page 33)

KB (E3.1 + E5.1) 11/2014 page 33/100
Program entry as set-point ramp (example):
W/°C
t/min.
S01 S02 S03 S04
0
20
40
60
80
100
30 120 180 380
S05
Program table corresponding to the diagram (with default setting “Ramp”):
Section
SEC
Temperature
set-point
[ °C]
TEMP
Section length
[hh.mm]
TIME
Fan speed
[%]
FAN
Operation lines *
O.LINE
S01 40 00:30 50 000
S02 60 01:30 100 000
S03 90 01:00 100 000
S04 90 03:20 100 000
S05 20 00:01 100 000
* Only with option zero-voltage relay outputs via operation lines, see chap. 16.4.
The values of such a program table can now be entered to the RD3 program controller (chap. 8.2).
Program entry as set-point step (example):
W/°C
t/min.
S01 S02 S03 S04 S05 S06 S07 S08
0
20
40
60
80
100
30 120 180 380