BINDER KB 23 - Manual (Page 52)

KB (E3.1 + E5.1) 11/2014 page 52/100
11.3 Proceeding in detail
1. Settings in the user level:
•
Setting the safety controller to “Limit” and 3 °C above the maximum temperature value of the
program
• Activating the week program timer
• Checking and, if necessary, setting the real time clock
Normal Display
Display 1 shows e.g. 19.8 (actual temperature value)
Display 2 shows e.g. 15.05.06 13:52 - -
(actual date and time, actual switching state of week
program timer channel 1: Off, channel 2: Off)
Press down key
for 5 sec
Display 1 shows e.g. 0000
Display 2 shows PROGRAM EDITOR (you are in the program editor)
Press down key
for 5 sec
Display 1 shows 0000 Menu visible only if week program timer is activated.
Display 2 shows WEEK PROG. EDITOR (you are in the week program editor)
Press down key
for 5 sec
Display 1 shows 0000
Display 2 shows USER – LEVEL (you are in the user level)
Press program key
Display 1 shows 0000
Display 2 shows UserCod? 0000 (enter user code, display flashes)
Enter the user code using arrow keys e.g. 0001 (basic setting,
or the valid code in case it has been
previously changed in this menu).
Value is shown in both displays.
Automatically forward after 2 sec
Display 1 shows 1 (actual address)
Display 2 shows Address 1
(entry of unit address)
(actual address: 1)
Press several times key
until Saf.mode appears:
Display 1 shows 0000 (no function)
Display 2 shows Saf.mode: Limit.
(select set-point mode of safety controller)
(actual setting: „limit“)
Select “ Limit” using arrow keys Setting is shown in display 2.
Press key
Display 1 shows 23 (actually set temperature value)
Display 2 shows Saf.setp 23
(temperature value of over temperature safety device)
(actual value: 23 °C / 73.4°F)
Enter the temperature value of 23 in °C
using arrow keys
Value is shown in both displays.