CIRCUTOR CEM-C30 series - Manual (Page 16)

4.4.- DISPLAY MODES:
The CEM-C30 has 2 display modes:
 Display in standby mode
 Display in reading mode
4�4�1� DISPLAY IN STANDBY MODE
With the display in standby mode, all of the information is presented in cyclic form without any
need to perform any action on the CEM-C30 buttons.
7 different parameters are viewed in this mode, see Table 6 , in which they alternate every
6 seconds.
The unit is in this mode by default when none of the buttons are pressed.
Short press the button to stop the cyclic movement of the parameter being shown at the
time.
From then on, short press the
button to browse all the parameters defined in Table 6 .
Table 6: Standby mode displays
Screen Parameters
Total imported active energy
Total exported active energy
Only displayed in the 4-quadrant version.
Reactive energy quadrant L+ total (1)
Reactive energy quadrant L- total (1)
Only displayed in the 4-quadrant version.
Reactive energy quadrant C- total (1)
Only displayed in the 4-quadrant version.
16
CEM-C30
Instruction Manual