CIRCUTOR CEM-C30 series - Manual (Page 26)

4�7�5� Type of communications
NB: This is only displayed if there is a CEM M-RS485 (communications interface for the CEM
family of units) connected to the unit.
This is the home screen for selecting the number of bits, the
parity and the number of stop bits of the communications frame.
Long press the button to view the value to be programmed.
This screen shows the different options:
8n1 : 8 bits, no parity, 1 stop bit.
8E1 : 8 bits, even parity, 1 stop bit.
8o1 : 8 bits, odd parity, 1 stop bit.
8n2 : 8 bits, no parity, 2 stop bits.
8E2 : 8 bits, even parity, 2 stop bits.
8o2 : 8 bits, odd parity, 2 stop bits.
Short press the button to browse the different options.
To validate the data, long press the button and the validation screen will appear
( Figure 13 ) indicating that the programming value has been saved.
After a few seconds viewing the screen shown on Figure 13 , the system returns to the
Communications type programming main screen.
Short press the button to access the next programming step.
4�7�6� Display
This is the home screen for selecting the unit display options.
Long press to access the partial energy display selection screen:
4�7�6�1� Partial energy display
This is the home screen for selecting the partial energy display
view option.
26
CEM-C30
Instruction Manual