CIRCUTOR CEM-C30 series - Manual (Page 30)

To write or modify the value, short press the button
repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit with a long press on
the
button, allowing the remaining values to be modified.
To validate the data, move to the last digit and long press the button; the validation screen
will appear ( Figure 13 ) indicating that the programming value has been saved.
After a few seconds viewing the screen shown on Figure 13 , the system returns to the CO
2
emissions programming main screen.
Minimum value: 0.000
Maximum value: 9.000
Short press the button to access the next programming step.
4�7�10� Partial energy meter deletion
NB: It is only displayed if the partial energy display has been selected.
On this screen you select whether or not to delete the partial
energy meters.
Long press the
button to delete the energy meters. The
validation screen ( Figure 13 ) will be displayed next, indicating that
the energy meters were deleted correctly.
After a few seconds viewing the screen shown on Figure 13 , the system returns to the Partial
energy meter deletion programming main screen.
Short press the button to access the next programming step.
4�7�11� Exiting the setup menu
When this screen is displayed:
Long press the
button to exit the setup menu.
Short press the button to return to the first setup point
( “4.7.1. Impulse output weight” )
30
CEM-C30
Instruction Manual