CIRCUTOR CEM-C30 series - Manual (Page 29)

4�7�8� Energy cost
NB: It is only displayed if the efficiency factors display has been selected.
This is the home screen for entering the energy cost per kWh.
Long press the button to view the value to be programmed.
To write or modify the value, short press the button
repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit with a long press on
the
button, allowing the remaining values to be modified.
To validate the data, move to the last digit and long press the button; the validation screen
will appear ( Figure 13 ) indicating that the programming value has been saved.
After a few seconds viewing the screen shown on Figure 13 , the system returns to the Energy
cost programming main screen.
Minimum value: 0.000
Maximum value: 9999.999
Short press the button to access the next programming step.
4�7�9� CO
2
emissions
NB: It is only displayed if the efficiency factors display has been selected.
This is the home screen for entering the ratio of the carbon
emissions.
The carbon emissions ratio is the amount of emissions released
into the atmosphere to produce a unit of electricity (1 kWh).
The European mix ratio is approximately 0.65 kgCo
2
per kWh.
Long press the button to view the value to be programmed.
29 Instruction Manual
CEM-C30