CIRCUTOR CEM-C30 series - Manual (Page 33)

To validate the data, move to the last digit and long press the button; the validation screen
will appear ( Figure 15 ) indicating that the setup value has been saved.
Figure 15: Validation screen�
After a few seconds viewing the screen shown on Figure 15 , the system returns to the main
screen of the Primary voltage transformation ratio.
Short press the button to access the next programming step
4�9�2� Voltage secondary transformation ratio
This is the home screen for entering the voltage secondary ratio.
Long press the
button to view the value to be programmed.
To write or modify the value, short press the button
repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit with a long press on
the
button, allowing the remaining values to be modified.
To validate the data, move to the last digit and long press the button; the validation screen
will appear ( Figure 15 ) indicating that the setup value has been saved.
After a few seconds viewing the screen shown on Figure 15 , the system returns to the main
screen of the Secondary voltage transformation ratio.
Short press the button to access the next programming step
33 Instruction Manual
CEM-C30