CONTA-CLIP SMS-MULTI I/O - Manual (Page 30)

SMS-MULTI-IO
- 29 -
5.6.2 5.6.2 5.6.2 5.6.2 Reading an
Reading an Reading an Reading an RTD RTD RTD RTD input input input input
To retrieve the status of an RTD input, send: rui rui rui ruin , where n is the number of the requested input. The
module answers: ‘status RTDn=xxxx’
When a user defined name is given to an input it can be addressed by putting the name between
asterisks. E.g. an output is called ‘server room’ you read the status by sending
r* r* r* r*server room**** . The
module answers: ‘status server room=xxxx’
NOTE: To receive a user defined confirmation message from a non user defined input name the user
has to read the input by sending:
r* r* r* r*rtdn rtdn rtdn rtdn**** .
5.7 5.7 5.7 5.7
Read all IO statuses
Read all IO statuses Read all IO statuses Read all IO statuses
To retrieve the status of all IO’s sent: rall rall rall rall . The module will answer:
‘read DO1=x, DO2=x, DO3=x, DO4=x’
‘read UI1=xxx, UI2=xxx, …(to)… UI8=xxx’
*
‘read AO1=xxxx, AO2=xxxx’
*UI is replaced by the chosen input: AI, DI or RTD.