Paxton Superchargers Dodge V-10 Truck - Manual (Page 7)

Section 2.0
INITIAL PREPARATION AND DISASSEMBLY
2-1
P/N: 4800019
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
25SEP03 v2.0 Dodge V-10(4800019v2.0)
Fig 2-a
Fig 2-b
Fig 2-c
I n this section, you will be preparing for the
installation procedure by disconnecting the
battery cables and removing and relocating
a few pieces to make room for your new
Paxton supercharger.
2.1 INITIAL DISASSEMBLY AND
REMOVAL:
A. With a 1/2” wrench, remove both bat-
tery cables.
B. An 8mm wrench or socket is used to
remove the battery hold-down. Lift the
battery out of the tray and set it aside.
C. Unclip the cruise control cable from the
throttle body and mount if equipped.
(See Fig. 2-a.)
D. The tray is secured with two bolts and
two nuts above and two more accessible
from below. Use a 13mm socket with an
extension, and raise the battery tray
from the vehicle. (See Fig. 2-b.)
E. Use a 10mm wrench and remove the
cruise control actuator from the bottom
of the battery tray. Later it will be modi-
fied and reinstalled. (See Fig. 2-c.).
*** NOTE ***
On some later model trucks, the factory relocated
the cruise control actuator so this step will not need
to be done.