Pinnacle Systems DR - Manual (Page 39)

B -
Appendix “B”
Regulations and Guidelines
“...control system shall be constructed so that a failure
within the system does not prevent the normal stopping
action from being applied to the press when required,
but does prevent initiation of a successive stroke until
the failure is corrected” (ANSI B11.1-2009).
“...the control system shall be constructed so that a
failure within the system does not prevent the normal
stopping action from being applied to the press when
required, but does prevent initiation of a successive
stroke until the failure is corrected” (OSHA CFR
1910.217, 1988).
Safety Guidelines for Management
Operational Safety
1. Appoint a Safety Coordinator to be responsible
for safety regulations, requirements, and
suggestions. He must review and investigate
all accidents and “close calls.”
2. Establish and issue safety rules. Inform each
employee of his responsibilities. Make sure he
understands them and knows what is expected
of him.
3. A thorough review and an early inspection must
be made of existing presses, dies, and point
of operation guarding to attain the degree of
responsibility required by ANSI B11.1-2009
Safety Standards and Federal State laws.
Review what mandatory modifications are
necessary.
4. Equipment that is no longer safe and that cannot
be economically upgraded should be destroyed.
5. Never allow persons legally under age to
operate or assist in the operation of machinery.
6. All personnel must be properly trained to
eliminate accidents and injuries.
7. Regardless of the operator’s experience,
education, or language barrier, it is the
responsibility of the supervisor to give him
a thorough explanation with each new job
assignment.
8. No employee should be given a work assignment
that he does not fully understand. Only properly
instructed and thoroughly trained personnel
should be assigned to work on or with any
machine.
9. It shall be the responsibility of the employer
to provide an adequate, clean, safe, and
uncluttered work area around each machine.
10. If a malfunction is reported, stop the machine
immediately, correct the problem, then resume
production.
11. Investigate all accidents and close calls.
Analyze the reason for occurrence. Take action
to prevent recurrence. Keep records of the
investigation and preventative steps that were
taken.
12. Only employees who understand the machines,
operation and safety requirements, and who are
able to communicate this knowledge should
be given the responsibility of instructing and
training others to perform as operators.
13. Management must decide that personnel
protective safety equipment is required to
perform each job safely. Items such as safety
glasses, shoes, gloves, helmets, hand pads,
spats, protective sleeves and material handling
equipment are common in the metal working
industry. If noise levels are excessive, protective
headsets and earmuffs are recommended.
14. When designing point of operation guarding,
the manufacturing process should be weighed
heavily in favor of operational safety.
15. Establish safe and convenient material handling
methods and procedures.
16. Post in convenient areas the names, addresses,
and phone numbers of physicians and hospitals,
and members of the organization who are to be
called in case of emergency.
17. All equipment must be electrically connected
according to the National Electric Code and be
consistent with other accepted practices.
18. Provide adequate and proper fi re protection
equipment.
Power Press Guarding
1. Press manufacturers do not know and cannot
foresee the magnitude of potential
applications of power presses. Therefore,
only the press user can determine the type of
guards that have to be used in order to perform
the job safely. It is the responsibility of the
user management to make certain that point of
operation guarding and other necessary safety
devices are installed. The press should be
guarded in such a manner that it is impossible
for the operators to place their hands or any
other part of the body in the die area.
2