Pinnacle Systems DR - Manual (Page 42)

D - 1
Appendix “D”
USB Diagnostic Codes
Model MG or DR USB Diagnostic Codes: Master Controls USB port
Note: You must install the Silabs CP210x USB driver on your windows PC. Check your Device
Manager for Silabs COM port#. You read the port at 230400 Baud 8N1
Char Description
B or b First or Second Pylon set Blocked repeats when # of blocked beams changes
M or m First or Second Pylon set Blocked during MUTE-OUT condition Guard stays GREEN
C or c First or Second Pylon set Cleared after a Block
E or e First or Second Pylon set no Blocked beams during MUTE-OUT condition
K Light Curtain in MUTE-OUT (Guard was GREEN before going into MUTE-OUT)
k Light Curtain no longer in MUTE-OUT
S Check EEPROM
Ee Start & Stop ReWriting EEPROM
Should only happen 1 st time programmed
Q Fault found active in EEPROM at Startup Previously powered down with an
uncleared Fault
E AutoBlank load Should always see this
“Soft Ver= R34r.1012.MG” Scroll this string on LED display
Only RST F1 push can interrupt this
M Version Display scroll finished
“RST” String on LED display
Then jmp to FAULT routine
Fx Enter Fault() routine
x: 0=Slave in Fault() routine, 1=Slave not in Fault() routine Should be F0
W Writing to EEPROM new Fault code
V<cr> Clearing Active Fault Someone Hit RESET button while in a Fault
x y x & y: upper and lower bytes of Fault Code just cleared. Displayed in HEX
z Return from Fault() routine Not first time returning
P<cr> Return from Fault() routine First time returning
0
1
.
9 9 lines of 2 byte HEX showing the last 9 Fault Codes First to Last
v Hold RESET button down at power-up LED displays 9 fault codes
p End of Fault
G First Time return from FAULT()
A Run Initial pylon TEST One time after power-up only
xxxx m Pylon length , performing SHORT LED test 1 SCAN of pylon
“Wait” Done with initial SHORT LED SCAN
x* If numbers appear without an F, then problems communicating with Slave
g Bad Auto Blank memory