Proceed CDD - Manual (Page 27)

27
As soon as you release the button, play resumes.
If you search past the beginning or end of a track, the laser pickup will move on
to the previous (or next) track. If you try to search forward past the end of a CD
or program, the laser pickup will stop at the end of the last track. If you try to
search backward past the beginning of a CD or program, the laser pickup will
stop at the beginning of the first track of the disc (or playlist).
Direct Time Access You may use time on the Remote Control to begin play at a specific time on the
disc.
1. Select the desired track using either next and previous or the
numeric keypad on the Remote Control.
2. Press time , then press the numbered buttons corresponding to
when you would like play to begin. (The numbers you select will
appear in the
time portion of the display.)
3. To begin play at that point, press play . (To pause the disc at the
same point, press pause instead of play . This allows for extremely
precise “cueing up” of a disc when making a recording, for ex-
ample.)
Note: The time you select depends on the selection you’ve made
with the display mode button: elapsed or remaining, CD or track.
For example, if you want to begin play one minute and thirty seconds into track
2, select track 2 by pressing
2 on the remote control. Press time , enter 1 3 0 , then
press play . (This example assumes that the most recently used display mode was
elapsed time on track.) If you do not press play , the CDD will timeout after ten
seconds (that is, it will “forget” that you had begun to do something, and revert to
normal operation).
Alternatively, you might want to set the CDD to play music for a specific period
of time. Say you’d like to listen to music until the evening news begins in 30 min-
utes. Make sure both the
time on disc and time remaining LEDs are on (indicat-
ing time remaining on disc, the default display mode when in stop ); press time ;
enter 3 0 0 0 ; and press play . This sequence will direct the CDD to a point 30
minutes from the end of the disc, and engage play at that point. When the music
ends, you will know it is time to turn on the news.
Repeat Disc To repeat (continuously) all tracks on a CD, press repeat until the disc repeat
LED is lit. To return to normal play, press repeat again two more times (to cycle
through track repeat to normal play ). Pressing stop will also restore the CDD to
normal (non-repeating) operation.
Repeat Track To repeat (continuously) the track in (normal) play, press repeat twice (to cycle
through disc repeat to track repeat ) . While the track repeat function is active, the
LED above the button is lit.
This feature is helpful (for example) when trying to learn how to play a particular
song by playing along with the disc. To learn sections of the song, you may want
to use the Repeat A-B function described below. Once you have most of the sec-
tions learned, you can put them together with a track repeat.