Proceed CDD - Manual (Page 33)

33
no button is pushed for more than ten seconds, the CDD will “time out”
and return to normal operation.
special commands table Command Display
positive control for operate L 1
positive control for standby L 2
display on L 3
display off L 4
A–B repeat L 5
Numeric Keypad: 1 L 6
Numeric Keypad: 2 L 7
Numeric Keypad: 3 L 8
Numeric Keypad: 4 L 9
Numeric Keypad: 5 L 10
Numeric Keypad: 6 L 11
Numeric Keypad: 7 L 12
Numeric Keypad: 8 L 13
Numeric Keypad: 9 L 14
Numeric Keypad: 0 L 15
Direct Access by Time L 16
display toggle L 17
random L 18
index L 19
4 MOMENTARILY PRESS THE REPEAT BUTTON TO TRANSMIT THE SELECTED
CODE
Line up the IR window of your remote control with the left side of the dis-
play of the CDD, at a distance of approximately 2"-6". Select the to-be-
learned button on the remote, then fire the selected code from the CDD by
pressing
repeat . (If you are uncertain as to how to prepare your remote con-
trol for learning new commands, refer to the instructions provided with the
remote control.)
5 REPEAT THE PROCESS OF “TEACHING” NEW SPECIAL COMMANDS
UNTIL ALL DESIRED COMMANDS HAVE BEEN LEARNED BY YOUR
REMOTE CONTROL.
If you take longer than approximately ten seconds between button pushes,
the CDD will time out and return to normal operation. If this occurs, return
to step #1 in this section. You may either cycle through the entire list by
pressing
program + repeatedly, or move backwards through the list by
pressing program – .
6 WHEN FINISHED, RETURN TO NORMAL OPERATION BY ALLOWING THE
CDD TO “TIME OUT”
The CDD will “timeout” and return to normal operation after approximately
ten seconds. (Alternatively, you may press and hold the repeat button to
force the CDD back into normal operation.)