TabletKiosk Sahara NetSlate a230T - Manual (Page 74)

Chapter 06: Upgrading Your Sahara NetSlate 59
1. Turn off your computer, turn it
over and place it face down on
a solid, flat surface. Be careful
not to place it on something
rough that could damage the
display screen.
2. Locate the RAM module
compartment near the
center of the back panel of the
system, just above the docking
connector. Remove the two
screws that secure the RAM
module compartment cover
(use a #0 Philips head screw
driver).
3. Lift the cover from the edge
where the screw holes are
located to remove it and set
it aside. Inside is the RAM
slot. Depending upon your
system’s configuration, it will
either be empty or populated
with an existing module.
4. If it is empty, proceed to step
6. Otherwise, using your
fingers or a small screwdriver,
press the two metal restrain-
ing clips on both sides of the
RAM module outward and
away from the module. The
top edge of the RAM module
should pop up slightly when
freed from the restraining
clips.