Televes High Definition TV Satellite Receiver, zAs HD SAT - Manual (Page 19)

19
EN
Through this menu you will be able to make the ZAS HD
SAT record an event at a programmed time. Up to 20
different events can be programmed.
 The list is displayed empty if no event is created.
This function is only possible if you have an
external drive formatted with FAT 32, a pen
drive (memory stick) or a memory card reader.
Create/Add an event
keys or and press OK to confirm.
To add a new event, press the OK key over the option
Timer on the Main Menu.
 Select one of the timers with the cursor or keys
and press OK to confirm.
Channel: Indicate the channel to be recorded once the
receiver is turned on. By default, it displays the current
channel. Select another one with the keys or .
Date: Enter the date for the event.
Starting Time: Enter the starting time for recording.
Ending Time: Enter the time off for recording
Repeat: Indicate whether this process is performed only
once (“No Repeat”), “Everyday” or “Every week.”
Finally, press OK on the remote control unit o activate the
timer.
Delete an event
 A list of programmed events will appear on the “Timer”
menu in both manual format as well as through the EPG.
See par. 7. Electronic Program Guide (EPG).
 To delete an existing event, position the cursor over the
EPG and press the red key.
- The time shown on the adapter is sent by the
service provider. Very rarely, it might happen
that this time is not correct. Check this before
programming an event.
- During the procedure of a Timer only programmes
of the same Multiplex can be seen.
- Events cannot be created if the start or end times
are lower than the current ones.
- Events cannot be created if the time overlaps.
10. Timers