High definition tv satellite receiver – Televes High Definition TV Satellite Receiver, zAs HD SAT User Manual
Page 26
26
High Definition TV Satellite Receiver
Unicable
Your facility has a Unicable system, where you can connect
up to 8 receivers in a single cable.
In the “IF Channel” option, select one of the 8 IF channels
for your receiver.
If the center frequency for the selected channel is not
correct, select another in the “Center Frequency” option.
Select one of the two ports on the “DiSEqC port” option
and assign a satellite to this port on the “Satellite” option.
The level bars will tell you if you have the satellite signal
and what is the strength and quality for each TV channel.
By pressing the yellow key is shown the LNB Setup
submenu, where you can modify the offset of the LNB
(+1 V).
By pressing the blue key displays the submenu where
you can select Advanced Settings values “ Auto”,1, 2, 3, 4
and 5 for the “Repeat DiSEqC” option.
Automatic channel searching
Using this menu option, it automatically searches for all
available channels in the band of the selected satellite in
“Antenna Configuration”.
Select “Automatic Channel Search” option and press OK.
Before you start a channel scanning, you must specify the
requirements of the search.
In Scan Mode, indicate if you want to search: All channels
(“All”) or free-to-air channels (“Free Only”).
In Channel Type, indicate the type of channels you
are searching for: only “TV” , only “Radio” or both “TV &
Radio”.
Indicate if the search is going to be performed across
the entire network, “Yes”, or only on transponders stored
in the receiver, “No”.
Press OK to confirm the settings and continue.
The search may take a few moments. Please wait.
To stop the search at any time, press EXIT.
After the search, the screen will show the number of
channels found of both TV and Radio.
Press OK to start watching the channels.