Additional commands – Argox Ethernet printer User Manual
Page 5
Ethernet Printer Technical Manual November 10, 2010
5
2. Additional Commands
Parameter types:
-
None: no parameter is required
-
Signed integer. e.g. +100 or –23
-
Unsigned integer. e.g. 32
-
Signed byte. Just one byte binary data. e.g.
+3 is represented as 0x03(03H), and –1 as 0xff (0FFH).
Command
Description
<ESC>KIZA
*Enable/disable the switch detection of the print head if it is opened.
*Syntax: <ESC>KIZAm
*Parameter:
m = 0; disable the switch detection of print head if it is opened
(default)
m= 1; enable the switch detection of print head if it is opened
If this function is enabled, the label auto-calibration will be performed when the print head is
closed.
<ESC>KJA
Request the printer status through Ethernet to be displayed on the web
page. Information about the printer status is listed in
TABLE1
.
<ESC>KJB
End Job
<ESC>KJH
Enable the printer to check if Ethernet card is alive or not every second.
<ESC>KJI
Disable the printer to check if Ethernet card is alive or not every second.
<ESC>KJJ
Start Job
<ESC>KJK
*Reset the printer function.
*Syntax: <ESC>KJKm
*Parameter:
m=0 disable the reset function (default)
m=1 enable the reset function
This command is for printer configuration.
<ESC>KJL
*SNMP broadcasted function setting.
*Syntax: <ESC>KJLmnq
*Parameter:
m= 0, disable the Ethernet card to enquire to reset the printer
(default)
m=1, enable the Ethernet card to enquire to reset the printer.
n= 0, disable the SNMP function (default)
n=1, enable the SNMP function
q= 1~9 seconds;
which SNMP enquire for the