Argox Ethernet printer - Manual (Page 8)

Ethernet Printer Technical Manual November 10, 2010
8
“b,b,b,b,”: subnet mask
“c,c,c,c”: Ethernet card gateway
Parameters must be HEX values.
*Example:
IP address:192,168,0,42
(“a,a,a,a,”=”0xC0 0x2C 0xA8 0x2C 0x00 0x2C 0x2A 0x2C” )
If “a,a,a,a,”=”0x00 0x2C 0x00 0x2C 0x00 0x2C 0x00 0x2C”, the setting will
become DHCP (auto IP address).
<ESC>KJYB * IP Address setting
(Communication between PC and printer )
<ESC>KJYBm,a,a,a,a[,b,b,b,b,c,c,c,c]
*Parameter: Parameter m is the setting mode; all parameters of the address
must be in HEX format.
Parameter m a,a,a,a b,b,b,b c,c,c,c
Mode
0x31 Gateway Ignored Ignored
0x32 Subnet Mask Ignored Ignored
0x33 Subnet Mask Gateway Ignored
0x34 IP Address Ignored Ignored
0x35 IP Address Gateway Ignored
0x36 IP Address Subnet Mask Ignored
0x37 IP Address Subnet Mask Gateway
TABLE1: PARAMETER ID
Parameter ID
( 4 bytes)
Length
(bytes)
Settings
All Parameters 0 0
Firmware Version 2 24 ( Up to 24 characters )
Printer Resolution 5 4 0: 203 4:100
1: 300
2: 600
3: 900
Standard RAM Size 7 4 4GB
Available RAM Size 8 4 4GB
Standard Flash
Memory Size 9 4 0: 2MB
1: 1MB
2: 4MB A: 1GB
B: 2GB
C: 4GB