Artesyn XMCspan Installation and Use (June 2014) - Manual (Page 19)

Hardware Preparation and Installation
XMCSPAN Installation and Use (6806800H03C) 19
The following table provides an estimate of the typical and maximum power required.
The following table shows the power available when the XMCspan is installed in either a 3-row
or 5-row chassis and when PMCs are present.
1 Keep below power limit. Cooling limitations must be considered.
2.2.1 Backplane Power Requirements
The following table lists the backplane power requirements.
Board Variant Measured Power Notes
XMCspan 7.5 W 1.5 A at 5 V
XMCspan with 2x MEN
P601 13 W 2.6 A at 5 V
XMCspan with 2x PMC
Test Adapter 38 W 7.6 A at 5 V
XMCspan with 2x PrPMC-
280S 39.5 W 7.9 A at 5 V
Voltage Maximum Current Available Power
+5 V 9 pins at 2 A 90 W
+12 V 1 pin at 2 A 24 W
-12 V 1 pin at 2 A 24 W