Artesyn XMCspan Installation and Use (June 2014) - Manual (Page 22)

Hardware Preparation and Installation
XMCSPAN Installation and Use (6806800H03C) 22
7. Align the module over the XMCspan.
8. Align the connectors on the underside of the module with the corresponding connectors
on the XMCspan.
9. Align the keying hole on the module with the keying pin on the XMCspan.
10. Gently press the module onto the XMCspan.
11. Turn the XMCspan component-side down.
12. Insert the four short Phillips screws supplied with the XMCspan through the holes on the
underside of the module, into the standoffs at the corners of the base board, and then
tighten the screws.
Note: Some PMCs use a screw at each corner; others require only two screws at the forward
corners.
Mezzanine
Card Slot
Connectors
Mezzanine
Card Slot 1 When installing a PMC/PrPMC module, use the following connectors:
J11, J12, J13, and J14.
When installing an XMC module, use J15.
Mezzanine
Card Slot 2 When installing a PMC/PrPMC module, use the following connectors:
J21, J22, J23, and J24.
When installing an XMC module, use J25.