Artesyn XMCspan Installation and Use (June 2014) - Manual (Page 46)

Functional Description
XMCSPAN Installation and Use (6806800H03C) 46
5.14 Debugging Support
The XMCspan has an 8-position DIP switch that is mainly used for factory testing and
debugging.
The following table describes the function of each position on the switch.
CLK_PCIE1 ICS9DB108 100 MHz Tsi384 Bridge 1
CLK_PCIE2 ICS9DB108 100 MHz XMC Site 1
CLK_PCIE8 ICS9DB108 100 MHz XMCspan connector J4
CLK_PCIE9 ICS9DB108 100 MHz Tsi384 Bridge 2
CLK_PCIE10 ICS9DB108 100 MHz XMC Site 2
Table 5-2 Clocking Scheme
Clock Signal Clock Source Frequency Device
Table 5-3 Debugging Support
Position Default Function
SW1-1 OFF Factory use only
SW1-2 OFF Factory use only
SW1-3 OFF Factory use only
SW1-4 OFF Factory use only
SW1-5 OFF Factory use only
SW1-6 OFF This is used to enable 133 MHz PCI-X mode for the PMC
slots.
SW1-7 OFF Factory use only
SW1-8 OFF Factory use only