Hardware preparation and installation – Artesyn XMCspan Installation and Use (June 2014) User Manual
Page 25
Advertising
Hardware Preparation and Installation
XMCSPAN Installation and Use (6806800H03C)
25
8. Place the XMCspan on top of the VME base board.
9. Align the mounting holes in each corner to the standoffs and align XMCspan connector P3
with VME connector J6.
10. Gently press the XMCspan and VME base board together, and then verify that the
connectors are fully seated.
11. Insert four short screws (Phillips type) through the holes at the corners of the XMCspan
and into the standoffs on the VME base board.
12. Tighten the screws securely.
Advertising