Artesyn XMCspan Installation and Use (June 2014) - Manual (Page 31)

Chapter 3
XMCSPAN Installation and Use (6806800H03C) 31
Resetting the XMCspa
3.1 Reset Sources
There are many ways to reset the XMCspan. The following sources will generate a board level
hardware reset for the whole XMCspan, including the PEX8533 and other devices connected
to one of the PCI/PCI-X buses:
 Power-up reset
This reset occurs when the XMCspan is powered on.
 VME hardware reset
The VME base board has a single push button switch that provides abort and reset
functions. When the switch is pressed for more than 3 seconds, a board-level hardware
reset is generated.
 VMEbus reset
When the VME base board receives a VMEbus reset, it combines this signal with any
local reset signal. This resets all devices on the base board, including the XMCspan.
Reset Switch
The standard reset/abort switch has been omitted on the XMCspan.
Reset Controller
The on-board CPLD is used to handle power-up and reset. The LC4128V-27TN100C from
Lattice, which is a 100-pin TSSOP package, is used.