Baby Lock Spirit (BLPY) Instruction and Reference Guide - Manual (Page 11)

NAMES OF MACHINE PARTS AND THEIR FUNCTIONS
B-9
The names of the various parts of the machine and their functions are described below. Before using the
machine, carefully read these descriptions to learn the names of the machine parts.
Machine
■ Front View
a Top cover
Open the top cover to thread the machine and wind the
bobbin.
b Pre-tension disk
Pass the thread around the pre-tension disk when winding the
bobbin thread. (page B-31)
c Thread guide for bobbin winding
Pass the thread through this thread guide when winding the
bobbin thread. (page B-31)
d Spool pin
Place a spool of thread on the spool pin. (page B-38)
e Spool cap
Use the spool cap to hold the spool of thread in place.
(page B-38)
f Supplemental spool pin
Use this spool pin to wind the bobbin thread. (page B-31)
g Bobbin winder
Use the bobbin winder when winding the bobbin. (page B-31)
h LCD (liquid crystal display)
Settings for the selected pattern and error messages appear in
the LCD. (page B-20)
i Speaker
j Operation buttons (5 buttons)
Use these buttons to operate the machine. (page B-11)
k Embroidery unit
Attach the embroidery unit to embroider (page B-44).
l Thread cutter
Pass the threads through the thread cutter to cut them.
(page B-40)
m Thread guide plate
Pass the thread around the thread guide plate when threading
upper thread. (page B-38)
■ Right-side/Rear View
a Connector for the presser foot
Connect the embroidery foot “W+” with LED pointer. (The
embroidery foot “W+” with LED pointer is optional on certain
models.) (page B-46)
b Handle
Carry the machine by its handle when transporting the
machine.
c Presser foot lever
Raise and lower the presser foot lever to raise and lower the
presser foot. (page B-46)
d Air vent
The air vent allows the air surrounding the motor to circulate.
Do not cover the air vent while the machine is being used.
e Main power switch
Use the main power switch to turn the machine ON and OFF.
(page B-17)
f Power cord receptacle
Insert the power cord into the machine receptacle. (page B-17)
g Sensor pen holder connector
Connect the included sensor pen holder. (page B-55)
h Sensor pen jack
Connect the sensor pen. (page B-55)
i USB port for computer
In order to import/export patterns between a computer and the
machine, plug the USB cable into the USB port. (page B-51,
E-48)
j USB port for mouse / media
In order to send patterns from/to USB media, plug the USB
media directly into the USB port. (page B-50, E-47)
Connect the USB mouse to operate with mouse. (page B-51)
k Handwheel
Rotate the handwheel toward you (counterclockwise) to raise
and lower the needle. The wheel should be turned toward the
front of the machine.
NAMES OF MACHINE PARTS AND THEIR FUNCTIONS