Baby Lock Spirit (BLPY) Instruction and Reference Guide - Manual (Page 44)

UPPER THREADING
B-42
b
While holding the upper thread, press the
“Needle Position” button to lower the
needle.
a “Needle Position” button
c
Press the “Needle Position” button to raise
the needle.
d
Gently pull the upper thread. A loop of the
bobbin thread will come out of the hole in
the needle plate.
e
Pull up the bobbin thread, pass it under the
presser foot and pull it about
100 mm (approx. 4 inches) toward the back
of the machine, making it even with the
upper thread.
a Upper thread
b Bobbin thread
f
Replace the bobbin cover.
Using Threads that Unwind
Quickly
■ Using the Spool Net
If using transparent nylon monofilament thread,
metallic thread, or other strong thread, place the
included spool net over the spool before using it.
When using specialty threads, threading must be
done manually.
If the spool net is too long, fold it once to match it to
the spool size before placing it over the spool.
a Spool net
b Thread spool
c Spool pin
d Spool cap
Memo
• When threading the spool with the spool net
on, make sure that 5 cm - 6 cm (approx.
2 inches - 2-1/2 inches) of thread are pulled
out.
• It may be necessary to adjust the thread
tension when using the spool net.