Baby Lock Spirit (BLPY) Instruction and Reference Guide - Manual (Page 176)

ERROR MESSAGES
A-12
This file exceeds the data capacity and cannot be used. Use a
suitable size file. This message is displayed when the file size exceeds the data
capacity of the machine.
Confirm the file size and format. (see page E-46)
This function cannot be used while in the sensor mode. This message appears when the selected function is not
available with the sensor function. (see page B-55)
This key does not operate when the needle is down. Raise the
needle and press the key again. This message is displayed when a key on the LCD display is
touched while the needle is in the down position.
This USB media cannot be used. This message is displayed when you try to use incompatible
media.
This USB media is incompatible. This message is displayed when you try to use incompatible
USB media. For a list of compatible USB media, visit
“ www.babylock.com ”.
Transmitting by USB This message is displayed while the USB media is
transmitting.
Turn off the power and replace the needle plate. This message is displayed when the needle plate is removed
with the machine on or when the machine is turned on and
“Embroidery” or “Embroidery Edit” mode is selected (see page
B-20).
USB media error This message is displayed when an error occurs with the USB
media.
USB media is not loaded. Load USB media. This message is displayed when you try to recall or save a
pattern while no USB media is loaded.
Use the presser foot lifter button to lower the presser foot. This message is displayed when a button, such as the
“Start/Stop” button, is pushed while the presser foot is raised.
Marks Error Messages Cause/Solution