Baby Lock Maria (Previous Model) (BL23A) Instruction and Reference Guide - Manual (Page 55)

54
* Set the stitch width in accordance with the
thickness of the cord used.
1. With the buttonhole foot raised, hook the filler
cord on the cord spur at the back of the
buttonhole foot.
2. Bring the ends toward you under the buttonhole
foot until they clear the front end.
3. Hook the filler cord into the forks on the front of
the buttonhole foot to hold them tight.
4. Lower the needle into the garment where
the buttonhole will start and lower the foot.
5. Depress the foot control gently and sew the
buttonhole.
Each side of the buttonhole and the bartacks
will be sewn over the cord.
6. Remove the fabric from the machine and cut the
sewing threads.
7. Pull the left end of the filler cord to tighten it.
8. Thread the end through a darning needle, draw
to the bottom side of the fabric and cut.
• Corded Buttonholes
Stitch selector:
Presser foot: Automatic buttonhole foot
Thread tension: 1 - 5
Stitch length:
( 0.25 - 1)
Stitch width: 5
4
3
2
1
5
* To cut the opening and to reset for sewing the
next buttonhole, refer to the instructions on
pages 50 and 52.
5
4
3
2
1
• • •