Baby Lock Aventura (BLMAV) Instruction and Reference Guide - Manual (Page 132)

Editing Stitch Patterns
D-10
Changing thread density (for satin stitch
patterns only)
After selecting a satin stitch pattern, press on the editing
screen to select your preferred thread density.
Returning to the beginning of the pattern
You can return to the beginning of the pattern after trial
sewing or when the stitching is sewn incorrectly.
a
Press the “Start/Stop” button to stop the machine, and
then press on the editing screen.
→ Sewing returns to the beginning of the selected
pattern (“W”) from the point where sewing was
stopped.
b
Press the “Start/Stop” button to continue sewing.
Low density ( ) High density ( )
CAUTION
• If the stitches bunch when thread density is
changed to , return the thread density to
. If you continue sewing when the stitches
are bunched, the needle may bend or break.
Memo
• Even if you select a new pattern after changing
the thread density, the thread density remains the
same until you change it.
• You cannot change thread density for a combined
pattern after additional patterns are added.
Memo
• If this key is pressed when sewing is stopped,
patterns can be added at the end of a combined
stitch pattern. (In this example, “!” is added.)