Baby Lock Aventura (BLMAV) Instruction and Reference Guide - Manual (Page 87)

Overcasting Stitches
Sewing S-11
U
T
IL
ITY S
T
IT
CH
ES
S
Sew overcasting stitches along the edges of cut fabric to
prevent them from fraying.
Sewing overcasting stitches using
overcasting foot “G”
• Using the table below, refer to “Using the utility
stitch tables in the “Sewing” section” in the “Basic
operations” section.
* Stitch patterns can be selected directly by pressing the
numeric keys on the machine during preset utility stitch
mode. Refer to “Basic operations” section.
a
Attach overcasting foot “G”.
b
Select a stitch.
c
Position the fabric with the edge of the fabric against
the guide of the presser foot, and then lower the
presser foot lever.
1 Guide
d
Sew with the edge of the fabric against the presser foot
guide.
1 Needle drop point
e
Press the “Start/Stop” button to stop sewing when you
are finished, and raise the presser foot and needle to
remove the fabric by pulling it back.
Overcasting Stitches
Stitch name Stitch
BL
M
A
V
P
re
s
se
r f
oot
BL
M
S
P
/B
L
M
L
R
BL
210A
Stitch number
Overcasting stitch
1-15 15 * 13 *
G 1-16 16 14
1-17 17 15
G
a
CAUTION
• After the stitch width is adjusted, rotate the
handwheel toward you (counterclockwise).
Check that the needle does not touch the
presser foot. If the needle hits the presser foot,
the needle may break and cause injury.
1 The needle should not touch the center bar
• If the presser foot is raised to its highest level,
the needle may strike the presser foot.
1