Baby Lock Aventura (BLMAV) Instruction and Reference Guide - Manual (Page 196)

Troubleshooting
A-20
18
Selected pattern field extends to the outside of the
embroidery frame. This message appears when the selected embroidery pattern is larger than
the extra large embroidery frame. Reduce the pattern size, or select a
different pattern.
This message appears when the selected embroidery pattern is larger than
the embroidery frame selected when “Embroidery Frame Identification View”
is set to “ON”.
19
The bobbin thread is almost empty. This message is displayed when the bobbin thread is running out. Follow the
procedure described in “If the bobbin runs out of thread” on page E-23.
20
The bobbin winder safety device has activated. Is
the thread tangled? This message is displayed when the bobbin is being wound, and the motor
locks because the thread is tangled, etc.
21
The carriage of the embroidery unit will
move. Keep your hands etc. away from the
carriage.
This message appears before embroidery unit moves.
22
The pockets are full. Delete a pattern. This message is displayed when the memory is full and a pattern must be
deleted.
23
The safety device has been activated. Is the
thread tangled? Is the needle bent?
This message is displayed when the motor locks due to tangled thread or for
other reasons related to thread delivery.
24
The "Start/Stop" button does not operate with the
foot controller attached. Remove the foot controller. This message is displayed when the “Start/Stop” button is pressed to sew
Utility stitches or Character/Decorative stitches while the foot controller is
connected.
25
The USB media was changed. Do not change the
USB media while it is being read. This message is displayed when you attempt to select a pattern after the
USB flash drive in which the pattern is saved has been changed.
26
There is a pattern included that cannot be saved to
USB media. Save the pattern in the machine's
memory. Depending on the pattern, it may not be possible to save it to a USB flash
drive.
27
This pattern cannot be sewn with this mode. This message is displayed when the selected stitch is not available for the
specific function.
28
This pattern cannot be used. This message appears when you try to retrieve a pattern that cannot be used
with this machine.
29 This USB media cannot be used. This message is displayed when you try to use incompatible media.
30
Turn off the power and replace the needle
plate.
This message is displayed when you try to sew with a stitch other than a
straight stitch (middle needle position) while the straight stitch needle plate is
installed.
This message is also displayed when the needle plate is removed while the
machine is still turned on.
31 USB media error This message is displayed when an error occurs with the USB flash drive.
32
USB media is not loaded. Load USB media. This message is displayed when you try to recall or save a pattern while no
USB flash drive is loaded.
33
When the speed controller is set to control the
zigzag stitch width, the "Start/Stop" button does
not operate. This message is displayed when the speed control lever is set to control the
zigzag stitch width, and the “Start/Stop” button is pressed. Set “Width
Control” to “OFF” in the settings screen (page B-13), or use the foot
controller to operate the machine.
34
F** If error message “F**” appears in the LCD while the sewing machine is being
used, the machine may be malfunctioning. Contact your authorized Baby
Lock retailer.
Error messages Cause/solution