Burst Electronics HDLG - Manual (Page 3)

Hardware Installation
Connect a SD/SDI or HD/SDI video source to the Video IN of the HDLG and connect the SDI
Loop Output to your monitor. Video will pass through the HDLG without power applied.
The SDI Output BNC is for video output for either video overlay of logo onto the incoming SDI
video source, or 1080i-60/702p-60 outputs when the HDLG Generator Function
has been selected from the front panel.
Place the HDLogoGen Program Files Installation CD into your CD-ROM drive. Plug in and
connect the 12Vdc wall module to the HDLG and turn power on. Connect the USB2.0 cable to
the computer and then to the HDLG hardware. A pop-up window appears stating New
Hardware Found (see Figure USB1)
(Figure USB1)
HDLG HD/SD SDI Logo/Color Bar Generator 2