Code Blue IP1500 VOIP SPEAKERPHONE - Manual (Page 41)

Code Blue • 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com GU-137-E page 41 of 66
IP1500 and IP2500 Series
Administrator Guide
ACTION SCRIPT PARAMETERS (continued)
Place Call (continued)
When Answered: The default setting is
Normal Two-Way Conversation, the
option is to Play Custom Messages. A
message can be set to play Locally (at
the speakerphone) and/or Remotely (to
the Called Party).
Choosing this option will add another
option to the Place call sequence, And
Then.
The And Then choice allows the call
to continue through to normal two-way
conversation mode or Hang Up and
reset the speakerphone.
Note: In this feature, it is prohibited to use the same exact message in both local and remotely se-
lection.
In Call Commands: The default is Enabled.
All Remote Control DTMF tone commands
are available for use by the called party. The
alternate choice is Disabled, effectively locking
out all DTMF tone commands from the Called Parties control.
Control AUX Output
• Aux Outputs can be activated and deactivated throughout a Script.
• Aux Outputs can also be set to activate on incoming answered calls.
• It is strongly advised that when this feature is used no other configurations are enabled for an
Aux Output with Momentary Toggle selected in Hardware Settings.